...
LAZ IS 3 COLUMN FORM, LZ2 IS 2 COLUMN FORM
DEVICE assumes the following entries in the configuration file (cblconfi, csconfi, or cblconfig):
PRINTER-PSPOOLER
PRINTER2-PSPOOLER-DIRECT# WINDOWS DIRECT
PRINTER2-DLPT1# MS-Dos
PRINTER2-plp -dprintername -s# UNIX
Code 3 of 9 example (1234567890ABCDEFGHI)
234567890ABCDEFGH
Code 93 example (1234567890ABCDEFGHI)
(1234567890ABCDEFGHIAD)
Notice that Code 93 is shorter (more compressed) than Code 3 of 9. If your part number is 20 characters or larger you must use Code 93. If you plan to utilize Code 93, it will be necessary to re-initialize your tricoder by following the few steps shown on the next page. If you prefer, you can send your tricoder to RTA and we will re-initialize the tricoder for you; the only charge is the return shipping cost. If you choose to have RTA re-initialize the tricoder, please contact technical support.
...
Tricoders are shipped with Code 93 enabled. If you reset your tricoder, you will need to re-enable it. Follow the steps below to enable the tricoder to read code 93 bar codes.
- Scan the bar code under "Start Setup" (top left corner).
- Scan the bar code under "Code 93" (middle of sheet).
- Scan the bar code "0" under "Barpad Table" (upper right side).
- Scan the bar code under "End Setup" (top right corner).